LTECH UB4 Wall Plate

Available in Black color, White color available upon request Allows a prescribed degree of control without the Casambi app or lighting network access Long-range product, up to 200M / 650’ from wall plate to nearest control, in open air/ideal conditions Can be used with the following: Casambi CBU-A2D (with SWH, STC, DTW) LED by Design PWM5-Pro (with SWH, STC, DTW, SS TWH (when two-conductor utilization is sufficient), DS TWH, color changing non-digital) LED by Design DiMX (with SWH, STC, SS TWH (when two-conductor utilization is sufficient), DS TWH, color changing non-digital); include 5A 4CH decoder in these scenarios

Recommended control for color-changing digital DMX to SPI DRGB/W decoder supports both the UCS 2904 SPI RGBW and UCS 2903 SPI RGB controller IC on the LED Linear. This equates to the “receiver” and replaces our NF DMX PIXEL DECODER, which only supported UCS 2903 SPI RGB controller IC Compatible with other, non-Nova DMX sources including Nico Laudie, Pharos, MADRIX, and QLC+

Required control for Signature Series TWH to utilize its four-conductor design (to set color and brightness independently), and the recommended control for Design Series TWH For Signature Series TWH, requires two UNV drivers (use non-dim), and either one Casambi CBU-A2D for wireless control, or two hardwire wall dimmers for wired wall control (one for brightness, one for CCT), such as the following Lutron units which are easily obtained via many sources such as electronics distributors. For Design Series TWH, requires one UNV driver (use non-dim), with either one Casambi CBU-A2D for wireless control, or two hardwire wall dimmers, same as per above.

Recommended control for color changing non-digital (with Casambi Xpress-LR wall plate optional) Alternative control option for Signature Series TWH (when two-conductor utilization is sufficient) and for Design Series TWH (both with Casambi Xpress-LR wall plate optional) Alternative control option for SWH, STC, and DTW (all with Casambi Xpress-LR wall plate optional) 1-5 independent channels for up to five fixtures per 96W UNV drive or circuit, including the ability to mix any/all types of non-digital lighting We recommend a max wiring distance from the PWM5 output to the LED strip of 16.4’ to minimize signal distortion and voltage drop

This 5 amp, 4 channel decoder supports DMX512 signal bi-directional communication, achieves remote management of reading and writing DMX address (DMX master controller must recognize the RDM protocol). It provides 0-100% dimming or different lighting effects for static color, bi-color, RGB and RGBW LED products.